Front Gauge Squaregage Systems No time to observe the video? Read our CNC Squaregage Transcript. CNC Squaregage is a precision front gauging system for power shears consisting of a digital show, a computer unit, and one two or three mechanical drive models, depending on the application. The drives are spaced so that the operator can stand between the and manually reposition the workpiece. A movable squaring arm is located on top of one of the drives. Due to the effectivity of this system, a number of cuts could be made on the identical blank with out placing the piece down. Square gage rapidly repositions after every shear cycle with the operator indexing the part in opposition to the entrance stop and the squaring arm. The completed flank remains in hand to cut back retrieval time and eradicate material scratching. This video will handle among the common application points related to mounting the sq. gage to the shear. The optionally available air finger exhibiting here retract and are out of the way in which when the fingers travel from one point to a different. This allows the user to spin the workpiece and minimizes scratching. Notice that the fingers pull again three-eighths of an inch to clear the finger from the fabric earlier than retracting and moving to the subsequent gauge. Our hottest system is arrange as a triple drive with a ten foot or 12-foot squaring arm and two auxiliary six foot arms. Ball transfers are shown right here, which assist with materials dealing with. The squaring arm finger is ideally positioned two and five sixteenth of an inch from the square edge, which mounts on high of the square gauge arm.